Although EPA regulations have stabilized and are thought to be well understood, ever-increasing local requirements are changing the criticality of air permitting for engine-driven generator sets.
The generator''s prime mover must not have a starting aid to meet this requirement, except that a thermostatically-controlled electric water-jacket heater connected to the final emergency bus is
When discharging air vertically, because the generator is surrounded on all sides, can result in higher than ambient air temperatures being pushed into inlet vents.
If the engine room temperature exceeds 40°C (104°F), the generator must be derated per the generator derate schedule and cool outside air must be ducted directly to the generator air
Generator sets must be properly installed to ensure that cooling air is not restricted or artificially heated by nearby heat sources or from recirculation. Fortunately, installation influences can be simulated
(d) The generator set must be capable of carrying its full rated load within 45 seconds after cranking is started with the intake air, room ambient temperature, and starting equipment at
The installer must make sure that the total square inches of free air inlet opening is sufficient to limit the heat rise in the room to prevent the room temperature from exceeding the generator ''s operating
This document may be of assistance in applying the New Source Review (NSR) air permitting regulations including the Prevention of Significant Deterioration (PSD) requirements.
Reaching the maximum temperature of 374 o C is not a cost-effective option as reaching this temperature in saturated conditions also means reaching the water critical pressure (22.1 MPa), and
Air Inlets and Outlets: Inlets must be properly sized to allow sufficient airflow, and outlets must effectively remove hot air and exhaust gases. NFPA 110 specifies clearances to prevent
PDF version includes complete article with source references. Suitable for printing and offline reading.
